'xxx main' Picture Glue explodes your creative options by allowing you to glue magazine, comic book, or custom printed images inside your polycarbonate RC car body. Unlike conventional white glue, our formula dries completely clear yet still remains flexible enough to withstand the abuse of hobby car impacts. The only tools you'll need are a hobby knife or scissors, a bristle brush or foam pad, and a great imagination.
How to paint a Star Wars themed RC Car body
Features:
- Dries clear and flexible
- Water based and non toxic
- Instructions printed on jar
- Easy to use
- 1 fluid ounce
- Part # Z001
Directions - Shake well before use. Cut out an image from a magazine or other printed matter. Use a Scouring Pad to slightly rough the Lexan surface where the image will be glued. Apply glue evenly to the picture face using a sponge or fine bristle brush. Place picture on the inside of the body and position as needed. Gently pat out any air bubbles or creases but do not squeegee the image firmly or the delicate material may tear; be very gentle. It is ok to leave some glue and air bubbles under the picture as it will dry clear. Use a damp towel to remove excess glue from around the image. Apply an optional thin coat of glue on the back of the image to seal it. Allow to fully cure for 12 hours before spraying polycarbonate paint.
